Can U Repair A Camera Lens On A Samsung Galaxy S5

Introduction

To supplant the 16 megapixel rear-camera, follow the steps to remove all previous components required. Have total precaution when operating tools such every bit oestrus guns, as they can crusade potential health hazards.

Insert your fingernail or plastic opening tool into the divot at the top of the rear-facing camera.

Insert your fingernail or plastic opening tool into the divot at the summit of the rear-facing photographic camera.
Gently pry and twist the flexible rear cover off the back of the phone.

Insert a fingernail or plastic opening tool into the recess in the bottom right corner of the battery and lift upward.

Insert a fingernail or plastic opening tool into the recess in the lesser right corner of the battery and lift upward.
Remove the battery away from the telephone.

Utilize your fingers to remove the SIM carte

Make certain the battery, the SIM carte, and the MicroSD carte have been removed. If these components are not removed, they may get damaged when the heat is applied.
In this step yous'll exist using a rut gun. The heat gun operates at high temperatures, and it may harm you or the device if not used appropriately. Delight follow the oestrus gun safety procedures indicated in it's manual to prevent any harm.
Use a heat gun at an estimate altitude of 2-three inches from the phone to utilise heat to the telephone and loosen up the adhesive in the display.

Starting from the upper left corner, insert a guitar option in between the display and the phone case.

Use the pick to pry the display past sliding the pick in the direction shown.
Brand certain you pry the display around the edge of the telephone. At the bottom of the screen there is a thin metal strip that connects the display to the motherboard, and it can be hands damaged.
If whatsoever resistance is encountered, stop prying and reapply estrus to continue prying.

Use the pick to pry the sides and lower part of the display past sliding the pick through the phone.
If any resistance is encountered, stop prying and reapply heat to keep prying.

Using the guitar selection, lift the screen slightly.
You can remove the home push if desired.

Slightly lift, but practice not remove, the upper end of display assembly.
Do not remove the front panel entirely. It is notwithstanding attached by a connector.
If yous are reusing the abode button flex cable, be careful non to sever the cablevision from the home push. Adhesive can cause the cable to rip apart from the home button. While the home button will nonetheless piece of work, the fingerprint scanner volition not.

Use the precipitous tip of a guitar pick to lift the front panel assembly cable connector straight up off its socket on the motherboard.
Safely remove the front end panel assembly from phone.

Use a Phillips 0 screwdriver to remove all 12 Phillips #0 screws.

Push button upward from the dorsum side your phone (where the battery should become) to pop out the big grayness piece.

You should now accept two different pieces. To continue we will but utilize the piece with the motherboard (Shown on the correct side of the picture).